Inclusion #
New In-Box #
- Activate inclusion mode for the sensore by remove the platstic pull-tab from the back of the sensor. When the cinlusion process is complete, the LED on the sensor will be solid red, then go out
- Test the sensor. Place the magnet next to the sensor to represent a closed position. If the LED flashes ONE TIME, it is successfully communicating the TrustHab network. If the LED on the sensor flashes slow and steady for 5 seconds, you need to repeat the inclusion process
Unpackaged #
Perform the same steps as New In-Box, after the Exclusion process has been performed successfully.
Exclusion #
Exclusion mode on the senor is initiated following the same exact procedure as inclusion.
When the controller is in exclusion mode, remove the cover of the sensor, remove the battery for 10 seconds, reinsert the battery, and replace the sensor cover.
Factor Reset #
Factory Default To restore this sensor to factory default settings, follow the instructions in this manual to exclude this sensor from the Z-Wave network. Upon completion ofremoval from the network the sensor will restore itself to factory default settings automatically. Use this procedure only in the event that the network primarycontroller is missing or otherwise inoperable.Keeping Awake for Testing and ConfigurationTo save power, this sensor sleeps most of the time and is therefore not awake to receive messages from a gateway for testing. Removing the top case from thesensor will put in device into a tampered mode in which the sensor will stay awake and able to receive messages. Most of the time an end user would not do this, but if the sensor needs to be configured after inclusion, an end user can follow the instructions below for sending Wake-Up notifications